Sélectionner une page
{module [171|rounded]}

Vertical Jump Workout 14

  • Complete in straight sets with 2 minutes rest in between sets.

Kettlebell Swing

Starting Position: Hold one kettlebell between your legs and your body is in a bentover stance with your back flat.
Swing the kettlebell backwards and then forcefully swing the kettlebell forward to a chest level. Keep your arm straight and forcefully extend your hips, knees, and ankles.

Hang Snatch

Keep torso straight but bent forward at the hips slightly.
Explosively raise the bar by extending the hips, knee and ankle in a “jumping action”.
Keep your elbows out and shoulders directly above bar as long as possible.
Keep the bar close to the body.
Once you have extended the lower leg shrug your shoulders and at maximum elevation of the shoulders rotate the arms up and around above your head by exploding forward with your hips.
Slightly flex the hips and knees to absorb the weight.
This should be a fluid motion where all the steps flow together.

Hang High Pull

Keep torso straight but bent forward at the hips slightly.
Explosively raise the bar by extending the hips, knee and ankle in a “jumping action”.
Keep your elbows out and shoulders directly above bar as long as possible.
Keep the bar close to the body.
Once you have extended the lower leg shrug your shoulders and at maximum elevation of the shoulders start pulling with the arms.
Keep the elbows high during the pull until the highest point.
This should be a fluid motion where all the steps flow together.

Standing Machine Calf Raise

1) Step into provided shoulder pads. Adjust lever arm so that plates do not touch when lowering the weight.
2) Stand with feet hip width apart or stand on the edge of a step on the balls of feet with heels hanging over edge. Toes should be pointing forward.
3) Contract calves by pushing off balls of feet to raise heels up in air (standing on toes)
4) Lower heels and repeat.
5) Remember to keep knees slightly bent throughout movement to prevent any knee strain. Adjust weight load accordingly.

Lying Hamstring Curl

1) Lie face down on bench with pad adjusted to fit behind ankles. If machine does not angle upper torso downward, it is recommended that a pillow be placed underneath stomach.
2) Start position: Position knees below bottom edge of bench or pad. Legs should be straight with knees aligned to the lever arm axis of motion and hands grasping handles or side of bench (if applicable).
3) Raise lever arm by flexing at the knees past 90°.
4) Return to start position.
5) Remember to keep hips in contact with bench at all times. Do not hyperextend the low back during movement.

Share This